Elmomc SimplIQ Analog Servo Amplifiers-Flute Installation Bedienungsanleitung PDF herunterladen (Seite 27)

Flute Installation Guide Servo Control Operation

MAN-FLUIG (Ver. 2.301)

www.elmomc.com

4.6. Latch Mode (LM)

By connecting J2/7 to J2/8, the amplifier can be latched to Disable mode whenever a Short or

Over Temperature failure occurs. Disabling the amplifier temporarily (removing the power from

Enable pins J2/9 and J2/10) resets the latch. Be sure to restore the Enable connection when the

reason for the event no longer exists. For permanent selection, a simple short is recommended.

For remote selection, use the following scheme.

Figure 6: LM Remote Control

4.7. Amplifier Enable Logic

Pins J2/9 and J2/10 are the inputs of an opto-coupler, which must be energized to enable

operation of the amplifier. If the Enable input is kept high before turning on the amplifier, the

amplifier power output will be active immediately upon power on.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33

Keine Kommentare

Elmomc SimplIQ Analog Servo Amplifiers-Flute Installation Bedienungsanleitung Seite 27